Also, if you purchased an ICS product in the last twelve months and want an updated manual, send us your name, mailing address, product model number and serial number. One will be send to you at no charge. Fax the above information to ICS at (925) 416-0105 or fill out the message form .

488.2 Errata adds ibcCableLength to ibConfig command for NI HS488 handshaking.File size is 400 K

488-PC2 Manual has been updated to give you better instructions for installing and using the 488-PC2 Card and for preparing Visual Basic and C/C++ programs. File size is 476 K

488-PCI/PCM Errata to Revision 1 adds the NT installation pages missing from some manuals and clarifies the RECEIVE command termination parameter. File size is 20K.

4803 RlyDvr Addendum provides documentation for the 4803/2303 Relay driver Board.

4804A-7 Addendum for ANSI x3.28 protocol with Program F30145. Applies to 4894A-7s with Program F30146.

4806 Errata adds X-On/X-OFF control of the serial transmit buffer, new jumper positions, and the capability to add an extra character to the GPIB message sent to the serial device.

4813 Pulse Command Addendum adds commands to pulse the 4813's output lines. The pulse commands are available in 4813 boards with revision 00.04 and later firmware.

4861 Errata to Revision 1. Adds serial and GPIB configuration commands and serial programming information for the Model 2361.

4863/2363 Revision 8.1 Manual. Adds Network Protocol information for 2363s.

4864 Addendum. Adds new relay pulse commands.

4866/4816 Errata. Adds missing RS485 command to SCPI Command Table

4892 Errata to Revision 0. Adds a new command to the 4892 so it automatically generates a formfeed when the print buffer becomes empty.

4892B Addendum Adds a new IDLE command to prevent printers with idle timeouts or auto formfeeds from ejecting the page until the user is finished printing.

4894A/4804 Errata to Revision 9. Adds S Mode Programming Guide and a Program Example.

4894B/4804B Addendum Describes the new Revision 'B' escape sequence and provides programming examples.

4895 Errata to Revisions 1 and 2. Adds 9-pin PC COM port connections, command corrections and jumper positions for revision 3.20 and later 4895s.

4896 Errata to Revision 7. Provides a copy of Figure 3-4 which is missing in Revision 7 manuals.

4889A/B/L Errata to Revision 2. Shows improved 4889L Fiber-optic link specifications.

4899A/4819A/4809A Addendum Documents additional Modbus commands, including Floating Point commands, added to the 48x9A series GPIB-to-Modbus Interfaces.

4899/4809 Addendum. Shows how to read and write 32-bit Modbus registers.

8063 Errata. Corrects pin number errors in the 8063 Rev 0 manual.

8065 WebServer Addendum. Shows how to use the 8065's internal WebServer to configure the 8065's network settings.

GPIB AnyWhere™ Manual Initial release manual describes how GPIB AnyWhere can be used to remotely control GPIB instruments.

VXI-5538 Errata to Revision X2. Clarifies ENTERDW and ENTERDP commands. Adds GPIB Bus Error bit to ESR register.