GPIB to ANSI X3.28 Interfaces

ICS's GPIB to ANSI X3.28 Interfaces adapt older devices that use the ANSI X3.28 devices to the GPIB Bus. All ICS GPIB Interfaces are IEEE-488.2 compliant and HP-IB compatible.

Model 4894B-7 GPIB ANSI X3.28 Interface

Download 4894B-7
Data Sheet
4861B GPIB to Analog Interface datasheet
Photo- 4894B-7 GPIB ANSI X3.28 Interface • F30146 firmware converts printable ASCII character strings into the ANSI X3.28 serial protocol.

• User selectable single-ended RS-232 and differential RS-422/RS-485 serial signals.

• Use SCPI commands to setup the 4894B-7's GPIB and Serial configuration. All parameters are saved in nonvolatile flash.

• 1 U high Rack Mount Kit mounts one or two 4894B-7s.

• Includes US 115 VAC Power Adapter

See also
GPIB Cables


     

Model 4804B-7 ANSI X3.28 Interface Board

Download 4804B-7
Data Sheet
4861B Board GPIB Analog Interface datasheet
Photo- 4804B-7 GPIB to ANSI X3.28 Interface Board

• F30145 firmware converts printable ASCII character strings into the ANSI X3.28 serial protocol.

• User selectable single-ended RS-232 and differential RS-422/RS-485 serial signals.

• Can be used to replace obsolete ICS 4814 Interfaces.

• Connect to the rear panel with a GPIB Flat-ribbon cable or with a GPIB Connector/Address Switch Cable.

• Runs on 5 Vdc regulated or 5.5 to 15 V unregulated power.

See also
GPIB Connector/
Address Switch Cables

GPIB Accessories


   
     
GPIB ANSI X3.28 Interfaces, HP=IB ANSI X3.28 Interfaces, IEEE_488 ANSI X3.28 Interfaces, 4814 replacement,