GPIB and RS-232 to Modbus RTU Interface Board

ICS's Model 4819A GPIB to Modbus RTU Interface uses a simple, GPIB friendly command set to control Modbus RTU slave devices. The 4819A mounts on the rear panel with its GPIB and RS-232 connector protruding through the rear panel to make an economical installation for OEM applications.

The Model 4819A is easily controllable with any GPIB Controller and test application software such as Agilent VEE, National Instruments' LabVIEW, Visual Basic and C/C++.

Use the Model 4829A board to control Modbus RTU devices that require RS-485 signals.

Model 4819A GPIB to Modbus RTU Interface

• Provides GPIB and RS-232 control of a RS-232 Modbus RTU device.

• Converts simple GPIB commands into Modbus RTU messages

• Includes floating point commands for newer Modbus Controllers.

• Handles all packet and CRC generation and response checking.

• RS-232 control path is fully transparent for use with existing Modbus RTU control programs.

• Easily configured from GPIB bus with SCPI commands.

• All settings saved in non-volatile flash.

• Designed for rear panel mounting to save space and cable cost.

• Diagnostic LEDs show address and operating status.

• RoHS compliant construction.

See also

GPIB Cables

GPIB Accessories